Dual Bowden Extruder Mount for Filament Sensors XYZ DaVinci
Description
I remixed this with these sensors in mind: https://www.amazon.com/dp/B07P72MYMJ/ref=cm_sw_em_r_mt_dp_U_YRL9EbG0E6E41 This is mounted in the original stepper holes and the filament sensors are glued to the plastic. To make room, you will need to cut the plastic where the filaments will go. See the picture for clarification. Id recommend ABS, but PLA was adequate. The test piece is just to make sure the holes line up with the original stepper mounts.
Statistics
Likes
0
Downloads
0