Qidi Tech 1 Filament Spool Holder
Description
This is a filament spool holder for use on the Qidi Tech I that can accommodate larger spools than the one it came with. Some spools (such as the amazon basics) are just barely too large that the thread on the stock one cannot reach the nut on the back of the printer. This solves that problem by being slightly longer. It is printable with no supports and I printed slightly over kill at 5 layers think on sides and with 25% infill and the part seems fairly strong even thought I printed in PLA. I also printed at a higher temp (230c) to ensure better layer adhesion since I didn't really care what it looked like. This spool holder uses an M10 thread and could be used on any printer or spool stand that uses the same.
Statistics
Likes
1
Downloads
0