CR10S CR10 SKR MKS 1.3 1.4 Turbo Bezel BigTreeTech USB Micro SD card cover hole
Description
This is a bezel for when a BigTreeTech SKR 1.4 board has been fitted into a CR10S, if you cut a big hole it should easily cover it! Probably fits the SKR 1.3 too, may also fit other 3d printers as long as the spacing of the SD reader and usb socket is the same and also as long as the bezel is not too large for your printer. This bezel slips on over the Micros SD and USB socket then you glue the back of it to your case and will cover up any ugly holes! Two versions are here, only difference is on e says Bigtreetech SKR 1.4 Turbo and the other just says Bigtreetech. Cheers!
Statistics
Likes
4
Downloads
0