Arduino Uno mount for MK3(s)
Description
First and foremost this mount is for use with this Arduino Uno Case: https://www.thingiverse.com/thing:737829 3.5~/hr expected print time with the 10% infill. I wanted a mount for my Arduino Uno for the Prusa LED Quad. I decided to use my Arduino versus wiring directly into the RAMBO just because I didn't find any good material and didn't want to take any chances. I knew the Arduino Uno I could just pull output of it plugged in via AC Adapter and get the voltage I was looking. My first print I later realized it didn't clear the axis motor, but that has been resolved in this upload. The only thing I'm aware of that might be any problem is the screws are self tapping just use some short spare screws that comes with your Prusa printer and push down while getting them started they will thread, but the issue is I have the hole off by a mm or so and you have to play around a bit to get them lined up. I tend to screw both screws where they are slightly sticking out of the part then work on lining them up one at a time. For the top screw I recommend using a flat head screw, but those are included in the spare bag also. I tried to include some pictures of the install. With the Arduino Uno mounted like this you only need a a matter of inches with your wiring which will make for a cleaner install. I hope this is helpful to someone. Feel free to remix or improve upon it. Here is the Quad LED that I am aiming to achieve clean wiring for: https://www.thingiverse.com/thing:2518558 I remixed this to use the MK3s axis tops so if anyone would like those let me know and I will upload those and link here. I don't think there is much of a difference except the MK3s is closed off where as there is a hole in the top for the MK2 version in the link. P.S. You can flip the Arduino with the plugs facing up or down either or will work. Thanks!
Statistics
Likes
0
Downloads
0