anycubic ultrabase - kossel delta - bedplate fan
Description
This is a mount for a 120mm or 140mm fan, to cool the self releasing "Anycubic Ultrabase" faster on a Delta / Kossel printer with 2020 extrusions. You still need some extra 90° angles, T-nuts and bolts (i used 5mm hex bolts) The angles are slightly off, but if you drill out the holes a bit more it should be fine WIRING I wired mine in the motherboard of my anycubic kossel plus, with an optocoupler-relay module in between GCODE my ending g-code M400 ; let every move finish M42 P43 S0 ; CUSTOM bed fan ON (doublecheck if the pinnumber is the same as yours) (my printer (and bedfan) shuts down automaticaly via octoprint) my starting gcode: M42 P43 S255 ;CUSTOM bed fan off (extra check to make sure its off before heating. Put this before everything else)
Statistics
Likes
2
Downloads
0