Ford Nugget Paper Towel Roll Holder
Description
This is my non destructive paper towel roll holder for the Ford Nugget 2006-2013 model. It needs a 6mm rod (aluminium, hollow). I will measure it next time I disassemble it but I think it is about 40-60cm long. The cheapest I could get is a 1m rod that I sawed down to the needed length by trial and error. Yes, I know, it is a lot of material for a simple paper towel holder but I wanted it there in the middle on the kitchen block so I could reach it from the kitchen and from the dining table. And it's robust and not weak. The slots are chamfered so you don't destroy the plastic protection when changing the roll. Please mirror the .STL model for left and right side! ======================================== Unfortunatly it needs a lot of material and many hours of printing time but it does the job and won't break if you print int in PETG.
Statistics
Likes
1
Downloads
0