Loom Strop - Leadingedge
Description
Leather (Or fabric) Loom Strop - Leadingedge design This is my loom strop for razor, knife, scalpel and tool stropping / sharpening. It gives the best possible surface (in my opinion) for stropping razors, knives or sharp tools. Stropping surface area for this design - 40mmx200mm. One side can be coated with a honing paste or spray and the other side left plain leather. Parts needed: 2 x Steel rods - 6mm diameter x 210mm length. (Make sure they are the same exact length). 1 x M5 Brass threaded insert (Or a M5 nut could possibly be used, but not recommended). 1 x M5 Thread - 70mm long. (I cut the head off of a 70mm long M5 screw for mine). Leather - Cut a strip 40mm wide x 450mm long. (A 1.5 inch plain leather belt will also work). Leather needles, thread & hole punches (It is best to stitch the ends of the leather or fabric together). NOTES: As al alternative to leather, you can use 40mm / 1.5 inch cotton webbing; linen; denim fabric; seatbelt webbing etc. If desired, you can also make a Longer strop, by simply using longer steel rods and a longer strip of leather. STEPS: -Print all parts (I used PLA with 100% infill). -Thread and epoxy glue your M5 thread into the handle. (I made a wooden handle for mine, but the 3D printed handle in my downloadable files will work just fine) Make sure that approximately 40mm thread still protrudes out of the handle. -Stitch the 2 ends of the leather / fabric strop together with about a 15mm overlap. -Use the "Threaded Stop" printed part as a template for marking the position of the 3 holes that you need to punch in your leather strop, then punch the 6mm holes in your leather. -Melt your brass M5 insert into the centre hole of the "Threaded Stop" printed part. (You should be able to use a M5 nut on the inside of the "Threaded Stop" part if you don't have any brass inserts but I highly recommend using brass threaded inserts. If using a nut, then I suggest to heat up the nut so it can melt and seat into the plastic a little bit) -Assemble all your parts (See my photos as your example) -Tighten the handle as much as desired to have a nice tight and stable loom strop. -When not in use, I recommend loosening the tension a little bit, so you don't stretch out your leather unnecessarily. If you find my designs useful, please go ahead and click on "Tip Designer" to the right of the photos at the top of this page. Proceeds will be used to purchase printing filament so I can keep designing and testing cool new things that you might find useful. Thank you! NOTE: Some of my other useful designs: https://www.thingiverse.com/leadingedge/designs
Statistics
Likes
43
Downloads
0