Mazda MX5 - Fiat 500 side repeater bezel
Description
Designed to allow installation of Fiat 500 side indicator repeater units. Fits NA, NB, NC. May also fit other cars as long as the studs on the indicator unit will fit through the original side repeater hole and the bezel is large enough to cover any holes in the wing. I suggest printing the rear holder as a solid in ABS. In an ideal world I would turn the outer bezel from aluminium or stainless steel but a solid 3D print would work too. You will need to unbolt the arch liner to access behind for the nuts. Install with the dimples on the rear holder facing towards the bezel. They have been designed to apply the clamping load over a small surface area to reduce the chance of slippage. If you like this please use the "Tip the designer" button just over there ---> somewhere. Many thanks Nick - Skuzzle
Statistics
Likes
5
Downloads
0