SRW-S1 mount for 70mm adapter
Description
This is my version of the SRW-S1 mount that works with any adapter that is 70mm (such as this for the T300, I use a similar design as this https://www.thingiverse.com/thing:2630578). It is designed using OnShape. You will need 1 M4 bolt (I used a Allen wrench bolt with a washer) to mount the adapter to the SRW-S1. You'll also need 6 M4s to mount the 70mm adapter. It is made to fit snugly, and therefore requires a pretty calibrated printer. The holes are tight to ensure that the FFB gets properly transmitted, I had to screw the bolts through the plastic to get them to go in. The mount is a bit wobbly against the SRW-S1 since it is slimmed, but I recommend that you glue the adapter to the SRW-S1 anyway to make it fit as tight as possible. I used simple superglue, e.i. cyanoacrylate. Epoxy glue might also work, just note that the backside of the SRW-S1 is painted in a rubbery paint that might interfere with some glues, but I haven't had any problems yet. Print with the 70mm side down to ensure that the holes on the SRW-S1 side are clean. I took some inspiration from these two prints, but I felt that the Thrustmaster one was a bit messy and I don't use a G25/G27, so I made my own version. But I wanted to mention them as the help at bit to make my design. https://www.thingiverse.com/thing:2867209 https://www.thingiverse.com/thing:2711721 PS. If you want the lights on the SRW to work with most sim-games, check out FanaLeds, a free program that makes them work and become programmable is you so wish
Statistics
Likes
2
Downloads
0