Water Table Ryobi pump
Description
Battery powered kids water table With the fittings in this 'Thing' and the Ryobi water pump I made previously (https://www.thingiverse.com/thing:4425666) you can have a water table with a constant flow for tons of fun with the kids. I printed the water table washers with Sainsmart TPU and the other pieces with Hatchbox ABS. No supports needed. Once you have the files printed its easy to see where everything goes. The water table pump adapter and washers go on the bottom of the table-this is where the water is sucked into the pump. The faucet and upper filter go in the top cup of the water table. The faucet can be turned in different directions to produce a tornado effect as well (see pictures). If you don't have TPU you'll want to glue the fitting to the table, and the upper filter and faucet may have to be glued as well. Without the TPU washers the fitting will leak and get water all over the pump and battery. The other thing you'll need to do is seal the bottom area of the water table (especially where the clear hose runs to the top cup) otherwise the table will leak all over. I used some foam and hot glue and it on leaks very little now. (I think the table was designed to leak so that a hose could be connected and water run constantly through it, but that wastes a lot of water really fast). Enjoy
Statistics
Likes
9
Downloads
0