Maker Farm 6'' Prusa i3 Cooling System
Description
This Part Was Created By Me To Be Used On A 6" Prusa I3 From Maker Farm (Www.Makerfarm.Com). In This Kit, The Original 40Mm Fan Was Designed To Avoid Heating The Upper Part Of The Extruder. But Without Controlling The Direction Of The Blow, The Original Kit Was Cooling The Heated Head And The Object That Was Being Printed In The Bed, Causing Some Warping. This Cooling Chamber Allows Just To Cool The Upper Part Of Extruder And Keeping The Blow Of Air Away Of The Print, Conducting It Upwards. This Is Made Of 3 Parts: 1 - The Fan Conductor - It'S 40X40Mm, And Made To Connect The Fan To The Extruder, Conduct The Blow Of Air Towards The Chamber, And Hold The Chamber In Place. 2 - The Cooling Chamber - This Directs The Fan Blow Of Air To The Heat-Sink Part Of The Extruder Head, And After That, The Wind Exits The Chamber From The Front. 3 - Chamber'S Cover - You Don'T Have To Disassemble The Extruder Because Of This Cover. It'S Made To Perfectly Fit The Chamber. This Closes The Chambers Gap. Check The Instructions To Assembling.
Statistics
Likes
81
Downloads
0