Ambrogio Amico Dog / Cat* Collar clip
Description
[* I don't have a cat and think they are likely too smart to be caught out, but who knows?] I have a dog that loves to lie in the garden soaking up the sun (when it is shining) and is so used to robots in the house, that I worry the lawn mower might hurt her. Ambrogio do a pet protecting tag which come with a collar attachment that lasted about 2 hours before she tore it off rushing around. As the Amico's are not cheap, I set about creating a more robust collar cover for it. It comes in two parts, the clip which fits her collar with is 20mm wide and 4mm thick and contains the Amico and a lid to hold it in place (although it fits quite snuggly). The first two versions of the lid clipped onto the case but after chasing the dummy through bushes etc, it soon came off. This version comes with spaces for 2 x M3 x 4mm (d) x 5mm (w) heatserts for the case - these need to be positioned carefully so as not to go all the way through - and the lid is held on with 2 x M3 x 4mm countersunk screws. Orientation: Case - I printed withthe base aginst the print bed so it was standing up. It worked well without supports but the clip is not completley smooth at the bottom curve, so it might be worth adding supports here. Lid - I printed upside down with 'tree supports' in Cura to give good qulaity screw holes, although they are not needed.
Statistics
Likes
2
Downloads
0