Improved Ender (3, 3 Pro, 5, 5 Plus, 5 Pro) Ball Bearing Filament Spool Holder
Description
#Improved Ender (3, 3 Pro, 5, 5 Plus, 5 Pro) Ball Bearing Filament Holder I was growing tired of the stock Ender-5 Pro filament spool holder, so I slightly modified it adding ball bearings and spacers. This will work for the Ender 3, 3 Pro, 5, 5 Plus, and 5 Pro.These are designed to be lightly tapped on (press-fit), so something like a rubber mallet would aid in install. This creates a tight seal against the existing spool holder, allowing the filament spool to rotate very easily while still looking somewhat stock. In order for these to be installed, the very endcap must be cut off (see attached picture). The stock release knob is still able to be used. ##The normal endcap requires removal by the stock thumb nut when changing reels. The compact one should fix this should you be annoyed by this. I flipped my plate around, so the reverse spool shim is not needed. If yours is like the cut image, it should be used. ###Ball bearings used: 2x 6906-2RS (30x47x9) ####DISCLAIMER: This requires slight modification of the filament spool holder, which I am not responsible for damage. Only attempt if you know what you are doing please.
Statistics
Likes
4
Downloads
0