Case for Xiaomi Mijia My Temperature and Humidity Monitor 2
Description
I bought a few of this sensors and they are great but they have a little flaw, the screen angle is terrible, if you let them standing up in the table o laying in their back the screen is almost black, they must have around 45º inclination in order to have a clear screen so i decided to build a case so i could actually read the temperature easily. There's no need of rafts or supports and prints great at 0.2, although the fit is a bit tight, once in the stand the sensor wont fall, actually it's a bit hard to take it of again if your printer tolerance is not similar to mine and comes out too tight or just want it a bit looser yo may want to increase it in the slicer by 1% or so Update 1: The case worked fine but the sensor had no air for the sensor, i've made an opening so it can "breathe", even though the readings were not that bad, around 1º higher than it should, but not precise, with the sensor opening it works as expected
Statistics
Likes
30
Downloads
0