CR10S PRO V1 UPDATED - BMG E3DV6 Direct Drive Mounting Plate
Description
With the new CR10s PRO v2, Creality shortened the plate witdh for all version, including V1. The original plate hits the left motor (X) before the plate hits the X homing sensor. I shortened the left side of the originel model, enlarged a bit some holes and created a hole to leave available the screw that clamps the roller at the top and left so that you can dismantle the metal plate without having to dismantle everything. This design have been tested with the "updated" V1, I think it should fit with V2 because the plates are the same (someone can give a feedback ?). Note : I use a BMG clone, a genuine E3D v6 and the stock Extruder motor. =============== UPDATE 13/04/2020 ============ Left part reduced again by 0.5mm to fit perfectly with the left side of the metal plate. The fixing holes of the original hotend are reused to be able to put M3 screws for better fixing on the plate. I added an extension to attach the cables and I took the opportunity to strengthen the part sandwiched between the BMG and the step motor. Finally, I added a small extension to attach the BLTouch cables and the hotend cables if you have them on the left side.
Statistics
Likes
9
Downloads
0