Etekcity Multimeter Desk/Benchtop Stand
Description
I needed a stand to hold my multimeter upright so I could see the display in the poor light of my shop and desk. This allows me to use both hands to hold the probes on components on a breadboard and easily see the reading. Designed in TinkerCad, I wish that there was an easy way to filet corners but I'll redesign it in something else later. Holds the meter with a cutout to leave the probes attached up front and a pair of 2mm holes in the back for the probe ends, I had to drill these out because I used a rough/fast print setting, you may need to enlarge them either way. Let me know in the comments if this was helpful.
Statistics
Likes
0
Downloads
0