Diatone Tina Whoop vertical Insta360 GO mount
Description
This is a vertical mount to hold an Insta360 GO on the Diatone Tina Whoop. 4 versions are available: 0 degrees, 10 degrees, 20 degrees, 30 degrees. 20 degrees appears to be the best version, but I've added the others just in case. Best way to install the Insta360 GO is to keep it vertical with the lens at the bottom, rotate on the vertical axis a little and insert it at an angle, then twist it into place. Print in TPU, 0.2mm layer thickness, 4 perimeters, no support needed. You can sell prints of this, but don't overcharge, and link back here. Tips are most welcome https://www.paypal.com/paypalme/Haku3D and will encourage me to make more designs for everyone to benefit.
Statistics
Likes
5
Downloads
0