Tesla Wireless Charger
Description
This is a wireless QI charger for the Tesla Model S and Model X. The chargers is based on an IKEA Wireless Charger, that means “everyone” could get one without figuring out what charger coil that fits this design. Dismantle the IKEA Charger, remove the two pad under it, unscrew three screws – keep then for later. Take out the electronics, and pop it inside this design. Screw the Lid on with the three screws. The Phone Holders are easy interchangeable. The “block” that fits into the charge plate are 29,4mm x 2,8mm and 10mm deep. Design your “claws” that fits your phone. The one attached here are for Galaxy Note 9 or 10 with Samsung Original Cover. The Charge Plate and USB are printed with support touching build plate. The Lid and Phone Holders are not. The Wireless Charger from IKEA is “LIVBOJ” about $5. https://www.ikea.com/no/no/p/livboj-tradlos-lader-svart-40447051/ Happy Printing! Update 2020.08.11: Added two more files. These have a rectangular lid, it looks a little better. WirelessChargerTesla_New_Base v35.stl WirelessChargerTesla_New_Lid v35.stl
Statistics
Likes
5
Downloads
0