EZR Struder Ender 5 Mounting Plate
Description
This will allow you to put the EZR Struder on the Ender 5. My Ender 5 Plus's extruder mounting plate blocked it due to the T Nuts for mounting it onto the back. This design allows you to run bolts through the top holes and put T nuts on the back to mount it in the same place while keeping the filament detector. I printed it with 100% infill as it needs to be firm. I believe I used M3x25 bolts and nuts for the filament run-out and mounting and M3x14 or 16 for screwing into the extruder motor. Make sure to tighten the extruder gear before mounting the detector as you need access from below to get to the set screw.
Statistics
Likes
6
Downloads
0