Rigidbot Community LCD cover with bracket.
Description
The Front Cover Is From Walter'S Design, I Just Added 0.5Mm To The Front Thickness As I Found The Bezel Around The Lcd Was Too Thin For My Liking. Also Increased The Size By 0.5%. The Lcd Fit At The Original, But Was A Bit Tight If You Need To Remove It For Any Reason. The Brackets Mount To The Holes On The Rigidbot Front Panel, I Did Not Use Any Nuts To Back Up The 4Mm Screws, Just Threaded Them Straight Into The Panel. The Backcover Has 4Mm Wells To Receive 4Mm Nuts. It'S A Tight Fit So I Suggest Positioning The Nut In Place And Using A Screw To Fully Seat It. The Cable Cover Is A Simple Clip On Affair That Holds The Pcb And Covers All The Exposed Solder Joints. I Also Made Buttons From Walter'S Thing With .5Mm Added To Keep Them Flush. One Has An E For E-Stop, One With S For Select, And One Blank. Since E Can Be Confused For Enter And S For Stop, I'M Open To Better Suggestions! Thanks Walter For The Original Design And Marvin For The Lcd Project! Update: Added A Stop Button I Made Yesterday Before Leaving Work. I Have Not Printed It So I Have No Idea If The Feature Size Of The Lettering Will Work Or Not. Print At Your Own Risk! Updated Update: The Lettering Is Too Small For A 0.4Mm Nozzle. The Octagon With Print Without Lettering.
Statistics
Likes
22
Downloads
0