Taz Pro Revised/Corrected Y-Axis Spacers (Rear & Left)
Description
Hello Internets. At the time of this writing, the Taz Pro OHAI seem to have a number of mistakes and inconsistencies throughout it for the Taz Pro. From my other creations, you may know I have speculated as to the reason for this - perhaps they were rushed to launch the Pro; Lulzbot has (and continues to have) some difficulties. Their posted screw lengths seem to be wrong (often too short) in a number of cases, but more worryingly - a few of their jigs appear to be wrong, as well. ... and you only notice that these jigs are wrong if you go to mount a single extruder on your Taz Pro. I have validated both through my own findings and from another owner of a Taz Pro that the offsets they apply to the Y-axis installation, both on the rear, and on the left side, differ from what the OHAI instructs, and similarly differ from the jigs they provide. I suspect they revised the tooling during their release rush but forgot to post corrected jigs. Or, maybe, they printed their jigs on a machine that was out of calibration, which caused their version of the jigs to print larger than they are supposed to be. Who knows. All I know is, for me, those jigs weren't right. I've taken it upon myself to fix that issue by revising their "official" jigs that they provide in their source repo and adjusting them to represent the values that I've found to be accurate. YMMV, I accept no responsibility for damage caused by using these, it may void your warranty, I could be wrong, just my opinion, and all the other standard CYA things apply. Enjoy.
Statistics
Likes
1
Downloads
0