Ender 3 - SKR 1.4 & Pi rear mounted All-in-One case with WIFI slot & cable chain clip
Description
A remix of the case made by talsit......and my first upload! I have these feet attached to the bottom of me Ender 3 to allow for a not so flat table top and to allow extra cooling underneath for the original placement of my Raspberry Pi: https://www.thingiverse.com/thing:3109537 I decided to take advantage of the extra space I had under my Ender 3 and make this case 60mm high and add a cable chain link, as well as adding a slot for the ESP wifi module. I placed screw holes for LM2596 converters on the side of the case to allow more room across the bottom of the case for more hardware or cable management. Large ventilation holes have been added to allow for plenty of cooling. I didn't place screw holes for the lids as I don't use them and it's easier to access if I need to. I have changed the design and specs a little since I printed it, so everything should be perfectly lined up. Hardware for assembly: 4 x 5mm M3 bolts to connect the two halves All other holes (fans, LM2596) are also M3. I used 8 x 10mm M3 for my two Noctura 40mm x 40mm x 10mm fans and 5mm M3 for mounting 3 x LM2596's.
Statistics
Likes
14
Downloads
0