Bulk Film Spooler
Description
A bulk loader for the film photographer! Just add two 48x48 mm squares of felt to make the light trap. I used a thick (~2mm) type of felt. Double up if your felt is thin. Use super glue! Print on the largest, flattest surface of each model. Use a raft at will if you're concerned the model will permanently adhere to the bed. The Crank is a nested assembly that nicely prints on its side with supports. The version pictured was printed before I added the following "finishing touches": Each cap is labeled with "ISO100" or "ISO400" so you can remember what's loaded. Embossed on the side of the body is a table showing the number of turns that correspond to the number of exposures (copied from a Lloyd Loader)
Statistics
Likes
54
Downloads
0