60mm Fan Intake attachment for Tevo Michelangelo 3D Printer
Description
This is an Fan Airflow intake attachment to add a 60mm fan on the outside of the Tevo Michelangelo printer to increase airflow and cooling over the controller board and stepper drivers. It attaches to the vented side of the printer without the need for screws or other hardware. I made this to make sure my stepper drivers, tmc2130, would not overheat and stall my printing. I've used this setup for a few months now without any overheating. I also replaced the stock 50mm Exhaust fan (12volt), that was inside the printer, with a 60mm fan (12 volt) to increase airflow. I designed a converter that can be found on Thingiverse here: https://www.thingiverse.com/thing:4552522
Statistics
Likes
0
Downloads
0