Phil's Phone Tray 1.0
Description
This is my first real attempt at designing a solution to de-clutter our end table. The tray has three slots - the first one is for my S20 Ultra, the 2nd one is for my wife's iPhone 11/XR, and the far right is my attempt at an Apple Watch rest with inlaid charger. I left a 3-5mm tolerance for the phones to allow for our phone cases, and built a ramp to make it easier to pull the phones out. The Apple Watch slot is roughly meant for a 44mm watch with a large band, but I'm sure a smaller watch would work just fine. The Apple Watch puck should fit perfectly inside of the circle on the right, and the user would feed the male end of the charger through the charging side of the tray. The .stl file is 200mmx200mm which puts it slightly too large to print on my Ender 3, so more work is needed. But I figured I'd upload to inspire other 3D printerheads. Eventually, I'm going to design a more piecemeal solution that lets me snap individual pieces in. Post your makes/remixes please!
Statistics
Likes
4
Downloads
0