Servo Bracket with 60mm LED light ring mount and remixed parts
Description
The Original Bracket Is Great, But My Prusa I3 Uses A Short (36Oz.In.) Nema 17 Stepper, Placing The Servo Too Close To (Touching) My Hot End. I Redesigned The Top Clamp To Accommodate The Stepper Plug, Thus Allowing Me To Move The Bracket To The Back Of The Stepper. I Also Shortened The Switch Arm To The Minimum Length That Would Fold Up Beside The Bracket, And I Modified The Recess For The Servo Horn To Accommodate The Non-Tapered Single Horn That Came With My 9G. Servo. The Horn Simply Glues Into Place With The Screw Side Exposed For Removal If Needed. Another Change Was Adding Arms To Support A 60Mm Led Ring. The Ring Is Attached To The Bracket Using Two Zip Ties, Which Holds The Ring Flat And Securely. (You Must Insulate The Top Of The Led Ring To Prevent Heat From The Individual Leds From Weakening The Arms. See Updates In The Instructions.) See The Drawings And Photos!
Statistics
Likes
14
Downloads
0