Ender 3 pro power fan shroud and silencer (short version) Meanwell  psu

Ender 3 pro power fan shroud and silencer (short version) Meanwell psu

Description

This is my make of a shorter, slimmer fan shroud and silencer. Its quieter, shorter and prints faster. You also get the benefit of still being able to use the printable power supply tool top tray. To print just make sure its face down with the fans upwards and use tree supports. How to fit. Remove one screw from the top of the power supply Fan and use it to bore the holes to the correct size by screwing it into the printed part before fitting. Doing this makes sure fan is always held by at least one screw and won't fall into the power supply case. To fit remove only the top screw from the power supply fan and use it to screw the printed part in place. Swivel the part so you can gain access to the second screw remove the second screw and swivel the printed part into position, Re-fit the last screw to the fan.

Statistics

Likes

5

Downloads

0