Improved centre modules that require no gluing.
Description
As it's difficult to glue the three components to the triangular washers making it flimsy, I remixed in Tinkercad so that it can be printed in a vertical orientation. It needs minimal supports, only at the base and the two deep grooves. It takes up little space so I was able to stack 6 on my Creator 3 and use Duplicate mode to make 12 of them (11 needed) in just over 12 Hours. They are very sturdy and will not break. Printed at 15% infill on Flashforge PLA. The second part is the single one for the High Gain Antenna
Statistics
Likes
7
Downloads
0