Creality Mod- Z Endstop Offset
Description
Mod that allows you to move the Z-stop limit switch (aka endstop) on your Creality printer. Printer Compatibility: CR-10s CR-10 V3 Ender 3 Let me know if it does or does not work for more printers. Installation: 1. Unplug Z endstop 2. Remove the entire T shaped support bracket by loosening (but not completely removing) the 4 hex bolts. 3. With the bracket off the printer, now completely unscrew these four bolts 4. Unbolt the Z endstop circuit board from the old plastic plate by unscrewing two hex bolts. 5. Install the Z endstop to the new 3d printed piece. If the bolt holes are too small, drill them out with a 2.5 mm drill or reprint with larger holes by using the "horizontal expansion" setting in cura 6. Reinstall everything in the reverse order as disassembly.
Statistics
Likes
21
Downloads
0