Mistral Superlight Centerboard Pivot Pin
Description
The old plastic pivot pin on the Mistral Super light finally completely degraded and fell apart, so I modeled this in Inventor. Easy to print, Used support and printed it one pin side up. I suggest 0.2 mm layers and at least 30% infill. I used PET and would suggest either PET or ASA or ABS over PLA but I'm sure PLA will work fine. You probably want to glue it in. Sand the hole and then glue it with not too much glue so that you can replace the pin easily if it gives out again. I used gorilla glue (a Polyurethane 1 part glue) but you could use epoxy or any waterproof glue.
Statistics
Likes
0
Downloads
0