Monoprice Mini Bed Upgrade
Description
These parts make up a total bed exchange for a Monoprice Mini. This add manual leveling to mine, which did not have it. Check out the assembly video: https://youtu.be/7QtzCL9a45Q \** UPDATED 1/3/2021 \** Heated Bed Upgrade: https://www.thingiverse.com/thing:4726170 All parts fit on the printer. I printed them using PLA. Used a 15% cubic infill for all parts. The rod clamps and bed trays need a brim. Bed ends should be printed on their back, with supports. This can also be used to extend the bed in the y-direction by replacing the linear rods and increasing the length of the tray spacers. Relationships for increasing the bed length: Bed = Rod - 30 Spacer = Rod - 62 Spacer = Bed - 98 Rod = Bed + 30 Parts: (2) Bed Ends (4) Rod Clamps (2) Belt Clamps (2) Bed Trays (2) Tray Spacers Hardware: (20) 20mm M3 screws (20) M3 nuts (8) M3 washers (2) Pens springs, cut in half Belt (about 30cm) Tensinoer (reuse from printer) Linear Rods (reuse from printer) Glass bed Z-Axis spacer Bellow are the purchased parts that I used for this, as well as the Z-Spacer I used. Belt: https://www.ebay.com/itm/Timing-Belt-GT2-16T-5mm-Bore-Pulley-5-Meters-For-3D-Printer-RepRap-Prusa-Mendel/254349190668?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649 Hardware Kit: https://www.amazon.com/gp/product/B07FCN64HV/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 Glass Bed: https://www.amazon.com/gp/product/B071RS7DB2/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 Z-Spacer (really any will work, this is just the one I use): https://www.thingiverse.com/thing:4563372
Statistics
Likes
5
Downloads
0