Cooler Master, Masterbox Lite 3.1 Mesh-frame Upgrade
Description
Open up your suffocating pc case with this mesh-frame insert. My case was getting too hot when summer temps hit 93+F (34C) so i decided to do my first case mod on a new case,since the intake ports on the front face were anemic I cut a big trapezoid and needed a frame that would hold a mesh in place to keep the interior away from most dust and cat hair. I ended up sliding some pantyhose over it and clicking it into the void I'd cut. dimensions: the full piece is meant to be 205mm along it's longest axis. the two parts, for smaller machines are: 102mm side to side for the top section 113mm side to side for the bottom i printed and used the bisected one because i wanted to check the tolerances on the joiner pieces. A little sanding of the insert on the centre may be needed depending on your material squish factor. Use some kind of adhesive I used Protopasta's CF PLA for mine; can't imagine you having too much issue with any other material.
Statistics
Likes
2
Downloads
0