Case for Pi1541 with RPi 3A
Description
A case for the RPi 3A with pi1541 I/O Adapter by Christan Gräfe https://www.hackup.net/2018/07/pi1541io-revision-4/ Features: Two IEC ports Power and Activity 3mm LED mounts (needs to be wired to the board) 1.3inch OLED display snaps in place (needs to be wired to the board) All connectors and SD-card slot accessible from outside. Secure with countersunk M2.5 screws (20 mm) from the bottom, the printable stand-off between the bords and a nut on top. Two screws on one side is usually enough as the GPIO connector holds the other side of the boards together. The boards needs to be inserted one at a time with the A/V+power connectors/button side first. The Pi is easy but it's a bit tricky to insert the Pi1541 while keeping the screws and stand-offs in place. The LID snaps in place and can be pried off. preferably by pulling at the IEC connector end.
Statistics
Likes
1
Downloads
0