Samsung Galaxy XCover 4 Case
Description
A Samsung X-cover 4 Case that will protect your phone until it falls apart. This is a total remake of the "Samsung X-Cover 4 Y-Cover" where I took away the headphone holders, and put a full back on with an opening for the camera. To make it sturdier I put some waves around the edge, and I also made it slight bit higher because I wanted to print it in PLA. I guess it will fall apart after a while as the PLA I used is a bit brittle, but in the meantime it will protect my wifes job phone. The STL file is a lot bigger as I remeshed it in Blender to get rid of artifacts and it now contains ten times the number of polygons. If you use it with a phone with a shiny surface remember that PLA is quite rough and can scratch the surface. Put some tape on the inside if that bothers you. Turn it with the backside DOWN for printing. Allow for support everywhere to hold up the small edge if necessary.
Statistics
Likes
4
Downloads
0