Ronin SC BLTHLDR 1.0
Description
I made this boltholder to add some weight to the rear area of the Ronin SC Gimbal to compensate high lens weight. My setup with a Sony A7III with the Sigma Art 24mm f1.4, which is a quite heavy setup for the Ronin SC. Because of the high lens weight (over 600g), I needed to remove the camera´s eyepiece already, but it would not swing freely in all directions. You can easily slide the Boltholder over the rear end of the camera mount, stick an 8mm metal bolt through it, add some nuts for additional weight,if you need. This allows you to slide the camera forward a tad bit, until it does not hit the gimbal motors any more. You might want it for: - Additional weight to compensate high lens weight - DJI Ronin SC You might want to print it in TPU medium because the BLTHLDR uses the flexiible material to sit nice and snug.
Statistics
Likes
11
Downloads
0