X328 Parts
Description
Parts pack for the X328 FPV frame. The motor adapters move the motors slightly out from the center allowing you to fit 9" props. I printed out of PLA and using 2212 motors they stay cool enough to not melt anything. I would recommend a more thermally resistant filament though. Add two M3 nuts per adapter and it uses the little opening on the end of the arm as a screw hole. I had to drill the carbon a little bit so the screw slides in without resistance. The GPS mount/lid is based off this thing here: https://www.thingiverse.com/thing:3245309. For the 5883 GPS unit, the mount goes on the front of the quad under the FPV cam. So, the camera mounts are sized to allow it to fit. I also used a heat gun to allow the gps to bend down a little to reduce visibility from the camera; its not required though. The antenna mount is off center to allow my XT60 plug to ziptie to the other half of the mount.
Statistics
Likes
4
Downloads
0