12 mm Laser Enclosure and Mini Turret
Description
https://youtu.be/_qFwcmI1bXw 10/12/2020 - Added Base v1.1 and Rotator v1.1 - Flips the screw and the nut to make it easier to adjust the screw from the bottom of the base. Reduced the diameter of the top part of the base so the enclosure can angle more towards the base in the event the base is placed horizontally. (See pictures for changes) This was designed to be used in a Halloween Laser Swamp, using lower cost Green Laser and Laser Line Lens. 12 mm laser enclosure that helps protect the PCB board on the laser if it is soldered onto it. The mini turret helps align the laser to wherever you need it. Max Laser body length is about 40 mm (see image). 08/14/2020 - Added Laser Case models for 35 mm - 39 mm laser body lengths. You will need to print two of the side arm; I only included one model, since it's same arm for both sides. You will need screws and two nylon pressure nuts. Screw sizes: 1 inch 6-32 screw 8mm 6-32 screw - cut 1 inch screw 2x 6-32 Nylon pressure nuts You can use Metric screws simply adjust the size to closest equivalent.
Statistics
Likes
7
Downloads
0