Small Monitor stand dampener stand (ADAM A3X)
Description
Ok, if you are here, you are looking for some dampener for your small audio monitor. Please have a look at these : i made them for my midrange ADAM A3X monitors, which are onto aluminium cone supports;these cones are settle onto small aluminium washers. These dampener allows to keep these washers in place, as well as dampening the low frequencies ( -12 dB measured at 1.5m, with a measurement calibrated microphone, using a mdf desk onto with 3x 4 racks units) I know this is very specific, but hey... some of us would need it maybe. even by printing there own conic dampeners support and washers ;-) I used TPU filament, 0.2 filament height at 210/50°C (sorry i dunno about F°) with Gyroid infill at 10% density. Be aware i dont use any cooling fan for the extruder : just the rad only. I joined my cura profile as well as my gcode, if you need to check and adapt it to your own setup and environment. The Cura profile includes ironing options : check it so it matches your own setup and filament. Take car eand have fun !
Statistics
Likes
0
Downloads
0