CamJam EduKit 3 Robot Chassis
Description
Robot Chassis for the CamJam EduKit 3 Robotics Kit Designed for - A power bank with max dimensions of 145mm x 68mm (Generally not limited on depth) (Link to the one I used below) - Raspberry Pi 4 (With an SD Card inserted) The dimensions of this motherboard with the SD card in are 87.8mm x 59.4mm - So it may fit other Pi's - Components in the Cam Jam EduKit 3 (Link below) Easy to assemble - See pictures for assembly notations Prints as one piece - I advise to print it with the top side faced down on the print bed; with supports. This top face is the one with the 3 square/rectangular cut outs for the power bank, Raspberry Pi and the Breadboard Assembly tips - Use some sticky pads to stick the battery box for the motors in. Make sure the on/off switch is facing outwards. The disc shaped holes at the front are for googly eyes if you wish to use them Power bank: https://www.amazon.co.uk/10400mAh-Portable-Charger-External-compatible/dp/B07JMP1FLN?ref_=ast_sto_dp EduKit 3: https://thepihut.com/products/camjam-edukit-3-robotics?_pos=1&_sid=ccf4d7f4f&_ss=r
Statistics
Likes
4
Downloads
0