Arduino Uno Stand with DFRobot LCD Keypad Shield Holder
Description
This is a remix of the Arduino Stand model from CreativeSkull. It's a nice design, but I found that LCDs (particularly the DFRobot LCD Keypad Shield v1.1 board) with pins underneath had no room to connect any wires. So, I adjusted the height and angle of the LCD risers to give me enough room to add wiring. There's approximately a full inch (25mm) of space beneath the board now. I also added a pocket to hold a pair of mini bread boards, and a pocket for holding screws or small components. This replaced the flat area for the 4xAA battery power pack in the original design.
Statistics
Likes
2
Downloads
0