Mavic Mini Floats (Pool Noodle Holder Landing Legs)
Description
mavic mini landing gear to hold a "standard" size pool noodle (2) (66mm diameter) should work with most and be a tight fit so shouldnt fall out. FILES: mavic mini floats.stl - body/frame " (1) and (2) are the right and left legs GCODE is for an anycubic i3 mega using ultimaker cura normal setting, ive changed infill and supports and speeds to print ok! This is like the after market kits that you can buy for about $15 on amazon but cheaper and printable ! if anyone prints it please give feedback in comments and i might make a V2 if needed! (plz tip if ive saved u money!!!) i will add pictures and a video when ive printed and tested it ! (still experimenting with printer settings) This will make your drone heavier so enable the payload mode in settings when using(1). Your camera may see the legs when looking down but im not sure yet, you need to cut pool noodle so size and make sure ur drone is balanced and not too heavy too one side. using this may use more battery from your drone. (3) (1) check caa/faa rules for drones over 250g as you may need to get a lisence to fly and it not may void warrenty/insurance or breach local laws (2) mavic minis are not rated or made to fly over water and may void insurance/warrenty so please check before using. (3) i do not take responsibility if anything should happen to your drone when using this. ALWAYS check for no fly zones and get correct permissions before flying !!!!!!
Statistics
Likes
12
Downloads
0