Dog bowl table
Description
This is a table for large metal dog bowls. I made this for my dog as she had to wear a cone and reaching the floor was difficult. It should fit bowls that measure ~220mm in diameter. You will need to remove the rubber ring. The table is 200mm tall. I need to print this on my ender 3 so I broke up the model into pieces. If you are doing the same the table parts need to be printed at 45 degrees angles so they fit on the built plate. I used supports from buildplate only for the table parts and a brim the legs do not need any support or brims/skirts
Statistics
Likes
4
Downloads
0