Ender 3 V2 PSU Cover 92mm Fan
Description
I found those really nice designed and remixed PSU Covers for the Ender 3 V2. The original design used a 92mm Noctua A9x14 Fan which was just screwed into the cover, the remix I am referencing added a cable guide and a fan holder but uses a 80x10mm fan. My design merges original and remix to fit a Noctua A9x14 PWM fan to the remix. The design has air vents and uses a bigger fan compared to the original Cover of the PSU thus more general ventilation takes place even when the fan is not spinning. So don't freak out if your fan is not spinning as long and often like the original one does. A user pointed out that clearance is too small on some power supplies thus the part is bulging a little bit. Please make sure you have enough clearance before printing.
Statistics
Likes
425
Downloads
0