Arduino Atmega2560 and RAMPS 1.4 case / box / enclosure
Description
This is a simple enclosure for Atmega2560 and RAMPS 1.4. It provides: * Enclosure body and cover * 4 mount holes for mounting the enclosure onto your project * 4 alignment corners and 4 snap on hooks to fit in your Atmega2560 (53.5mm x 102mm) and RAMPS 1.4. * Cutout and mounting holes for 40mm fans (up to 20mm fan height) * Holes to fit zip-ties (2.5mm) for cable mounting * Alignment structure for snap on cover * Holes to fit zip-ties (2.5mm) for securing the cover Total exterior dimensions when assembled: 137mm x 140mm x 65mm (enclosure body+cover) When the enclosure is mounted onto a base plate, the cover holds nicely by itself. When used free standing, one is advised to use zip-ties (holes foreseen). The design is to be installed with the fans facing downwards / blowing inwards. Air flow goes out on both open ends.
Statistics
Likes
2
Downloads
0