Flashlight Scope Clamp / Mount
Description
Drew Up A Little Flashlight Clamp To Mount My Red Flashlight To Scope For Hunting Coyotes. Both Diameters Of The Clamp Are Set Up For A 1" Tube. A 1/4 X 20 Bolt Is Used To Join The Pieces And I Added A Cap To The Bolt To Allow Adjustment Without Tools. The One Side Is Recessed To House The 1/4 X 20 Nut. I May Build Up The Bolt Side So A Spacer Is Not Needed With The Cap But This Works For Now. I Printed With Supports But You Probably Don'T Need Them (Makerware Only Added Support In The Center Of The Through Holes. The Scope Clears My 40Mm Objective But I Haven'T Tried It On The 50Mm. I May Have To Make The Entire Assembly Longer If It Is An Issue.
Statistics
Likes
286
Downloads
0