Creality Ender 3 V2 - Palette 2 Extruder Clip
Description
This is a remixed design for an Palette 2 Extruder Clip for the Creality Ender 3 V2 based on the initial design from Tproffen. It is simply mounted with the existing screws - No further changes required. There are two parts which should fit together quite nicely w/o any glue. The original rubber ring for the Teflon tube is required. There are still some minor improvements required, but the current design for the clip is working fine. Attention: After reassembly everything with the new clip the position of the nut from the threaded spindle could be slightly different, so keep in mind to do a new levelling of your print bed before you start any new print.
Statistics
Likes
10
Downloads
0