IKEA Mod filament spool holder stand
Description
Needed a filament spool holder and looked around in my home and found an IKEA book-end, and then designed this. The book-end is called BUSBASSE Book-end, made of metal, I bought these $3 each. https://www.ikea.com/gb/en/p/busbasse-book-end-white-00301908/ I design the letter B on outside and P on inside to match the book-end design. The holding rod was designed that the further end is a little bit higher so the spool would not slide out. Also the rod was half hollow to save some filament and time. Emboss some PLA text on the side, you can remove or change to what ever you like. Print it with the text side touching the bed, if your printer is good at bridging you can print without support ( even it fails at bridge it does not affect the functions) otherwise add some support to be sure. It is very stable. Print it in black and the black and white look would be great! unfortunately I am running out of black filament.... Hope you like it!
Statistics
Likes
0
Downloads
0