ScubaJet PRO - Battery Retaining Ring - v1
Description
Part of use with 2020 revision of ScubaJet PRO Dive Scooter. LIABILITY DISCLAIMER: Use this model at your own risk. By proceeding you acknowledge that the creator is NOT LIABLE NOR RESPONSIBLE in any way for any subsequent damages or injuries. The original battery stand-off that was on my 400Wh battery fell off, so I devised a simple retaining ring that can be glued (using marine rubber ferment) to the LED nose cone of the scooter. This is a much better setup than original. Note that proper final thickness tolerance in needed to make sure the nose cone screws fully on with correct water-tight seal and the battery can't slide forward. You might need to lightly sand the part to meet this exact tolerance, so there is no damage to scooter or dive problems due to battery becoming disconnected.
Statistics
Likes
1
Downloads
0