Control box and cable guide Ender 3 Pro
Description
I made a cabinet for my Ender 3 Pro, I am sure you have seen a lot of them and my one is based on the Prusa but extended for my Ender 3 see link below for all the parts I printed and used. I wanted it both ways, using original Ender parts and not cutting any cables etc. This way I could revert back to a stand alone printer if I ever wanted to. To do this I needed to design and redesign a few items. CONTROL BOX - see below for all steps to create this. LCD DISPLAY (Remix) - (see link below) Tucked away and flush with Ikea table when not using it but easy to pull out and lock in position when needed, also contains the Micro SD reader with a USB holder. HEAT BED CABLE - I came across the issue that the heat bed is too deep without modifying, so I used the 90 degree heat bed cable print, see link below. Flush mounted pull out LCD display. https://www.thingiverse.com/thing:4575761 Lack cabinet https://www.thingiverse.com/thing:3598219 Ender 3 pro 90 degree bed cable strain relief by kobb3 https://www.thingiverse.com/thing:4558474
Statistics
Likes
25
Downloads
0