Foil Track Ruler Stencil
Description
This is a stencil to help you stencil one inch ruler to bottom of a foil board. useful for Kitefoil, SUPfoil or Wingfoil boards. Two versions, due to 2 fonts. Use painters tape to hold it in place and a larger piece of paper, perhaps paperbag or wrapping paper to block overspray from board. I used PET but PLA most any material is good. Infill was 15% but since it's so thin, infill might not even get used. Layer height was 0.26 I believe. I used brim to help hold it to bed but I think that's not necessary unless you notice warping.
Statistics
Likes
1
Downloads
0